Cut three 30” lengths of wire. Attach a crimp with loop to each. Attach to a jump ring. Attach to another jump ring. Attach to toggle hook.
On each wire, string an inch of beads. String a silver bead over all wires. Repeat eight times. End with a purple bead over all wires.
Over two wires, string 5 E beads and a silver bead. String both wires down through two stacked buttons. Under buttons, string 5 more E beads. On remaining wire, string 5 E beads under buttons. String up through buttons and silver bead. String 5 more E beads. Over all wires, string one pink bead.
On each wire, string an inch of beads. Over all wires, string a silver bead. On all wires, string an inch of beads. Over all wires string a pink bead.
Repeat necklace pattern in reverse for a second side of necklace.
Attach a crimp with loop to each wire. Attach to a jump ring. Attach to another jump ring. Attach to toggle eye.
Make seven bead dangles of different lengths on eye pins. String beads as desired, make a simple loop at the top of each.
Cut a 12” length of beading wire. String on a crimp tube and the seven bead dangles. String end of wire back through crimp bead, forming a loop that holds bead dangles. Crimp. Trim wire. String up into silver cone.
String an inch of beads on wire above cone. Pass wire down through pink button. String on a crimp tube. Keeping crimp tube under button, pass wire up through both buttons and silver bead, back down through both buttons. pass wire up through pink button so it comes out between buttons. Pull everything snugly.
String on enough E beads to go around silver bead at center bottom of necklace and back down to crimp tube behind button. Wrap around necklace. String wire through crimp tube. Crimp. Trim wire.
Earrings
Attach a jump ring to button. Before twisting closed, place a kidney wire on jump ring. Twist closed. Repeat for other earring.
Tips:
Refer to photo for placement and assembly.
Using crimp tubes with loops: place beading wire in crimp. Pinch closed with chain nose pliers. Trim wire if needed.
Using a jump ring: grab ends of jump ring at either side of cut with pliers. Twist ring open. String through loop of toggle clasp. Twist tightly closed.
Randomly string bead sections or plan a pattern. The design is up to you.
Make a simple loop: bend wire at a 90-degree angle just above top bead. Trim wire to ½”. Grab end of wire, roll back toward beads to form a loop.
Adjust length of necklace by adding or subtracting 1” bead sections.
